|
|
本帖最后由 simulacrum 于 2026-11-17 16:00 编辑
Hello Ulanzi Team,
I am experiencing two recurring issues with my Ulanzi TC002 running firmware V1.0.17_1.1.4.
1. Wi-Fi connection problems
The TC002 occasionally loses its Wi-Fi connection and fails to reconnect automatically. Instead, it enters setup mode and displays the IP address 192.168.100.1.
The Wi-Fi network uses an AVM FRITZ!Box 6690 Cable with FRITZ!Repeaters 6000 and 3000 AX. The TC002 connects via 2.4 GHz Wi-Fi.
Power-cycling the TC002 immediately restores the connection without requiring any reconfiguration.
My Ulanzi TC001 running AWTRIX on the same network does not exhibit this behavior.
2. Display corruption
Recently, the TC002 suddenly stopped displaying the hours. Only minutes and seconds remained visible.
Additionally, all applications changed their display colors from white to green and blue. The original white display was no longer available.
The device remained accessible through its web interface and HTTP API. A complete power cycle restored the normal display, including hours, minutes, seconds, and the original white color.
Questions for Ulanzi:
- Are these issues already known?
- Is a firmware update planned to improve Wi-Fi reconnection and display stability?
- Are there any diagnostic logs or troubleshooting procedures that could help identify the root cause?
I would appreciate a response from the development team.
Thank you.
|
|